Food processor needed highly accurate volume measurements in order to know when to prepare to refill the bin, as the bin is almost always emptied completely before filling again to prevent damage to the material. The customer was seeking both accuracy and stability at batch empty rates of approximately one-half ton per minute, and was primarily interested in headroom or distance to product from the top of the silo. The material is very dusty and prone to sidewall build-up and bridging with the material surface being characterized by highly uneven topography during the emptying process. The 3DLevelScanner was being evaluated against radar systems from several different vendors
The MV model of the 3DLevelScanner was mounted on a 100 foot tall, 27 foot diameter, and carbon steel silo containing granular rice. The device was mounted on an existing flange using the BinMaster’s adapter plate and mounted one-sixth in from the silo diameter. The silo is a centre fill, centre discharge configuration and the internal bin environment is very dusty. However, the low frequency acoustics-based technology was able to penetrate the dust. Unlike the single point measurement radar devices, the 3DLevel-Scanner MV model samples multiple measurements
within a 70 degree beam angle inside the bin. Allowing material to settle in the bin and then visually mapping the contents helped the customer more closely manage inventory and schedule refilling at an optimal time and provided a more accurate estimate of bin volume. Based upon the success of the first silo, 27 additional units were installed at the location.
Sampling measurements from multiple points when the material surface of the bin is uneven provides a more precise headroom measurement and bin volume than a single point measurement device. The advanced mapping and visualization software – available on the 3DLevelScanner MV model – is helpful when used in material prone to sidewall build-up and bridging, where there are points in the bin that are lower or higher than the majority of the bin contents. Calculating volume after an empty or fill cycle, when there is a “cone down” or “cone up” can also be more accurate when multiple point measurement is used. Had a single measurement been taken, bin volume estimates could be significantly higher or lower than the actual volume.
Contact Pacific Sensor Technologies
Thank you for your enquiry! Pacific Sensor
Technologies will be in touch as soon as possible.
Sorry, there seems to have been an error.
Please double check your details and try again.
- High-Powder Ethernet-Compatible Three-Phase AC Motor Drives
- The Weighing Terminal for Smart Filling and Blending Applications
- Accuweigh Weighbridge Uses Avery Stainless Steel Load Cells for Cheetham Salt.
- Kinder & Co Awarded Prestigious Standards Certifications