Particle and Surface Sciences distribute the Micromeritics Accupyc 1340 Gas Displacement Pycnometer throughout Australia and New Zealand. For the measurement of density analysis, the Accupyc 1340 features improvements in design that allow the volume of small amounts of sample to be accurately detected and measured with enhanced reliability to within a fraction of a microliter. The 1340 has superseded the Accupyc 1330 Pycnometer.
For those who have a need to analyze a very limited amount of material, Micromeritics’ new AccuPyc II 1340 1-cm3 Gas Displacement Pycnometer performs fully automatic, high-speed, high-precision volume measurements and density calculations on a wide variety of powders and solids. The AccuPyc features improvements in design that allow the volume of small amounts of sample to be accurately detected and measured with enhanced reliability to within a fraction of a microliter.
A novel manifold design utilizes high-reliability, high-precision valves that seal more securely so that small leaks do not contribute to variability of results. High-compression, minimum-volume seals around the pressure transducer minimize helium storage and leakage. This shortens the time to complete a run cycle and practically eliminates the development of temperature gradients that would otherwise compromise results. The AccuPyc II 1340 1-cm3 also features an ultra-low noise transducer amplifier that results in faster equilibration.
The instrument can be operated with a keypad or an optional Windows® interface that provides exceptional reporting and archiving capability. Both versions include direct sample mass input from a balance and cycle-based displacement volume reporting. The Windows interface also includes time-based pressure equilibration, percent solids content, and total pore volume reports.
For those who require high throughput, an integrated control and analysis module can control up to five additional external analysis modules of the same or different volume capacities. A glove box model is also available for analyses in applications where the control module and analysis module must be in separate environments.
Particle and Surface Sciences are the sole distributors for the Micromeritics range of products throughout Australia and New Zealand. Particle & Surface Sciences also offer a wide-ranging programme of support solutions, including installation and service of all instruments by factory-trained technicians, an Analytical Laboratory and a Sales Department to assist with your enquiries.
Contact Particle & Surface Sciences Pty Ltd
Thank you for your enquiry! Particle & Surface
Sciences Pty Ltd will be in touch as soon as possible.
Sorry, there seems to have been an error.
Please double check your details and try again.
- Cordon for Safety and Access
- Stainless Steel Ducting for Food & Drug Makers
- Greasemax Manages Bearing Water Contamination Problems
- CleanSIGN Stack Light
More Articles From Particle & Surface Sciences Pty Ltd
- POLA 2000 for Particle Size and Counting
- Annual Conference of China Scientific Instruments Recognises Micromeritics GeoPyc 1365 Envelope Density Analyser as One of the Best New Instruments in 2017
- Mercury Intrusion Porosimetry Micromeritics Autopore V
- Surface Measurement Systems – Dynamic Vapour Sorption