Fresco Expands Pneumatic Conveyor Range
Fresco Systems Australasia has expanded their extensive range of pneumatic conveying systems by the addition of the V-Tec hopper loader range. The versatile V-Tec system comes in 7 different sizes and in either pneumatic or electric controlled versions. With capacities up to 9,000kg/hr and distances up to 30m it complements the larger Fresco pneumatic conveying systems. The V-Tec is ideally suited to the filling of packing machines, tablet presses, blenders, metering screw feeders and any other similar process systems. It can handle powders, granules, tablets and any other sticky free or non free flowing material. The multi stage vacuum pump is powered by compressed air and generates vacuums up to -92kpa.
The V-Tec is ideally suited to hazardous dust areas where traditional electrical equipment is expensive and untidy. The inbuilt pneumatic control system allows for a free standing unit which requires a single compressed air supply only. Conveying, discharge and dwell times are easily setup by the operator using the three dial knobs in the control cabinet mounted on the side of the hopper. The cycle timing is adjusted during initial setup matching the product conveyed and the system through-put rate.
The V-Tec system can convey product from drums, 20-25kg bags, bulk bags or bag dump hoppers by utilizing either a pickup wand or hopper charging adaptor. The conveying air flow can be manually adjusted to allow either lean or dense phase conveying. This minimizes product degradation and line wear while maximizing system through-put. The conveying cycle is a cyclic process filling the hopper then discharging at preset intervals.
The tangential inlet transition causes a cyclonic effect on the incoming product separating the product and conveyed air. The air then passes through the filter, multistage vacuum pump and out to atmosphere. The hopper exhaust valve opens discharging product into the down stream process below. The system continues until a signal is received closing the supply pneumatic air solenoid valve.
The V-Tec hopper loaders weigh from 10-36kg making them extremely light and transportable. Each unit can be easily dismantled into smaller more manageable sections allowing ease of relocation and cleaning by a single operator. The side mounted quick release clips provide extremely fast access and reassembly to all sections of the V-Tec hopper loader. Silicon seals ensure hygienic sealing between each section.
- Multi Stage Vacuum Generator
- Exhaust Valve
- Conveying line
- Pickup Wand
- Control Unit
- Air Receiver
Contact Fresco Systems Australasia
Thank you for your enquiry! Fresco Systems
Australasia will be in touch as soon as possible.
Sorry, there seems to have been an error.
Please double check your details and try again.
- Metal Detection System Installed For SA Salt Supplier
- Accuweigh Bag Filler for Concrete Additives Supplier
- Liquid Filling Machines Installed for Chemicals Manufacturer
- New Bean Cleaning Plant Commissioned